Product Safety Data Sheet

Home

Technical Support

Health & Safety

Safety Data - Granular

Product Safety Data Sheet - Group 8

Safety Data - Granular Fertilisers

INTRODUCTION

This Product Safety Data Sheet applies exclusively to products manufactured or marketed by members of the Agricultural Industries Confederation. It does not apply to any other product of similar name or nature. The products covered will be clearly identified by the name of the marketer and/or manufacturer on the associated labels and/or documents. Qualifying product will be marked as follows:

1. IDENTIFICATION OF THE PRODUCT AND THE COMPANY

1.1 Identification of the Product

Products in Group 8 are solid fertilisers which do not contain nitrogen (PK, P, K).

1.2 Company

See details below

2. COMPOSITION/INFORMATION ON INGREDIENTS

These products may contain some or all of the following ingredients. Normal (single) superphosphate, triple superphosphate, phosphate rock, potassium chloride (muriate of potash), potassium sulphate, inert fillers such as sand or limestone, and coating materials, such as oil, amine, clay or talc., secondary nutrients and/or micro-nutrients.

3. HAZARDS IDENTIFICATION

3.1 Human Health

Products are of a low toxicity but prolonged skin or eye contact may cause some irritation.
Ingestion: Small quantities are unlikely to cause toxic effects.
Large quantities may give rise to gastro-intestinal disorders.
Inhalation: Low toxicity dust but high concentration of air-borne material may cause irritation of the nose and upper respiratory tract with symptoms such as sore throat and coughing. Generally regarded as a nuisance dust with no specific official Occupational Exposure Limit (OEL). Recommend a total inhalable dust standard for nuisance dust of 10 mg/m3 as an 8 hour Time Weighted Average. See HSE Guidance Notes EH 40 and HSG 173.
Molten material: Will cause burns and inhalation of decomposition gases (eg in a fire) may cause serious lung effects.

3.2 Environment

As this fertiliser contains phosphate, heavy spillage may cause adverse environmental impact such as eutrophication in confined surface waters. See Section 12.

4. FIRST AID MEASURES

Product
Skin contact: wash the affected area with soap and water
Eye contact: irrigate eyes with copious amounts of eyewash solution or water for at least 10 minutes. Obtain medical advice if symptoms persist.
Ingestion: do not induce vomiting. Give milk or water to drink. Obtain medical attention if more than small quantities have been swallowed.
PSDS GROUP 8 PRODUCT
Inhalation: remove from source of exposure to dust. Keep warm and at rest. Obtain medical advice if symptoms persist.
Fire and Thermal Decomposition Products
Skin contact: wash areas in contact with molten material. Wash copiously with cold water. Seek medical advice.
Inhalation: remove from source of exposure to fumes. Keep warm and at rest.

5. FIRE-FIGHTING MEASURES

When the fertiliser is not directly involved in the fire use the best means available to control the fire.
When the fertiliser is involved:-
1. Avoid breathing the fumes. Wherever possible wear an approved breathing mask when fighting a fire or when fumes are being emitted.
2. Call the fire brigade.
3. Use plenty of water.
4. Open doors and windows to give maximum ventilation.
5. Do not allow molten fertiliser to run into drains.
If water containing the fertiliser enters any drain or water course, inform the appropriate water authorities immediately.
Note also first aid precautions (4).

6. ACCIDENTAL RELEASE MEASURES

Clean up spillage promptly. Sweep up and place in a clean appropriately labelled container

7. HANDLING AND STORAGE

7.1 Handling:

Avoid excessive generation of dust. Avoid unnecessary exposure to the atmosphere to prevent moisture pick-up.

7.2 Storage:

The basic requirements are the avoidance of involvement in a fire and contamination. Locate away from sources of heat, fire or explosion. Keep away from combustible materials and chemical substances taking particular care on farms to ensure that it is not stored near hay, grain, diesel, etc. Ensure high standard
of house-keeping in the storage areas. Do not permit smoking or the use of naked lights in the storage area. Buildings used for storage should be dry and well ventilated, stacks therein should be at least 1 metre from walls, eaves and beams. Further storage guidance is given in HSE Guidance IND(G)230L.

8. EXPOSURE CONTROL/PERSONAL PROTECTION

8.1 Occupational exposure limits

No specific official limits
ACGIH recommended value (1995-1996) for inhalable particulate: TLV/TWA 10mg/m3 .

8.2 Precautionary and engineering measures

Avoid high dust concentration and provide ventilation where necessary.

8.3 Personal Protection

Wear suitable gloves when handling the product over long periods.
Use suitable dust respirator if dust concentration is high.
After handling product, wash hands and observe good hygiene practice.

9. PHYSICAL AND CHEMICAL PROPERTIES

Appearance
White grey or brown granules crystals or
Powder.
Odour
Odourless.
pH water solution (100g/l)
Usually > 4.5.
Bulk density
Normally between 900-1100kg/m3 .
Solubility in water
Partially soluble in water, extent depends on
composition
Most formulations are hygroscopic.

10. STABILITY AND REACTIVITY

Stable under normal storage and handling conditions Liberates ammonia when in contact with alkalies eg Caustic Soda, Soda Ash.
Do not weld or apply heat to equipment or plant which may have contained the fertiliser without first washing thoroughly to remove all fertiliser.

11. TOXICOLOGICAL INFORMATION

11.1 General

See Section 3.1.

11.2 Toxicity Data

Product toxicity will depend on the composition.
Potassium chloride or sulphate:
LD50 (oral, rat) > 2000mg/kg

12. Ecological Information

12.1 Mobility

Partially soluble in water.

12.2 Persistence/Degradability

Phosphates, whether water or citrate soluble, are translocated in the soil over very short distances and are then immobilised. The dissolved potassium ion in the soil solution is adsorbed by clay minerals; where these are absent in light soils part of the potassium may be leached.

12.3 Bio-accumulation

The product does not show any bio-accumulation phenomena.

12.4 Ecotoxicity

Low toxicity to aquatic life.

13. DISPOSAL CONSIDERATIONS

Depending on the degree of contamination, dispose of by use on farm, by spreading thinly on open ground or to an authorised waste facility. Take care to avoid the contamination of watercourses and drains. Inform the appropriate water authority in the event of accidental watercourse contamination.

14. TRANSPORT INFORMATION

14.1 UN classification

Classified as non-hazardous.

15. REGULATORY INFORMATION

15.1 EC Directives

76/116/EEC (Relating to fertilisers)

15.2 National Regulations

The Fertilisers Regulations 1991 and subsequent amendments.

16. OTHER INFORMATION

This safety data sheet provides health and safety information. The product is to be used in applications consistent with best farming practice. Individuals handling this product should be informed under COSHH of the recommended safety precautions and should have access to this information. The product information in this data sheet is to the best of the AIC's knowledge correct as at the date of publication.
Neither the AIC nor the Manufacturer or Supplier accepts liability for any loss or damage (other than that arising from death or personal injury caused by negligence if proved) resulting from reliance on this information. Further information on individual products covered by this safety data sheet may be obtained from the Supplier or the Company whose name, address and telephone number will be found on the fertiliser container
Product Supplied by: Data Sheet Compiled by:
J & H Bunn Ltd, J & H Bunn Ltd [www.jhbunn.co.uk] South Beach Parade Great Yarmouth Norfolk NR30 3QA UK Phone +44 [0]1493 744700 Fax +44 [0]1493 744701